Usually map sensors have to be replaced and cannot be repaired.
what hose connects to the map sensor on a Toyota Camry
It's attached to the firewall next to the throttle body.
on a 1992 Camry the map sensor is attached to the center of the firewall by a bracket and has a rubber vacuum hose connected to it.
Backside, center of engine block right below the intake manifold.
The MAP sensor is located on the engine compartment on 1988 Toyota Corolla. The MAP sensor can be purchased at any auto parts store.
Toyota 1998 4cyl. have 2 oxygen sensors and MAF sensor. For more info and wiring diagram visit http://www.hhogear.com
If it's a 4CYL, It's on the firewall, center of the car. Follow the vacuum tube from the engine. It's very small.
The map sensor comes standard on a 1998 Toyota Rav4. It is typically located on the dashboard panel on the drivers side of the car.
It depends. If the sensor is working, just reset the computer. Otherwise you have to change the sensor.
The map sensor on a 1996 Toyota is on the fire wall, left side. It is a small piece that snaps into place and another tube that is placed into the map sensor. It is normally hung by a small piece that is connected to the fire wall.
To replace a light bulb in the map light on a 1996 Toyota Camry, the lens for the light has to be removed. There are clips at two opposite ends that have to be nudged gently with a flat screwdriver to get the lens cover off.
It doesn't use a Map sensor , it use a MAF sensor , and it is located right on top of the Air filter box