You could, but it would be safest not to. A time delay fuse will allow for a short (12 seconds or less) spike in the current (up to three times the rated current for the fuse). This happens when you start up a motor, or a compressor, etc... If you were to replace a regular fuse (say 2 amp) with a time delay fuse (also 2 amp), then instead of breaking the circuit at 2 amps, the circuit will go 12 seconds at 6 amps before shutting down. This could easily start a fire, so for your safety, it is best to replace a fuse with the exact same kind that came out of it.
No
Often confused with time delay, dual element is a term describing fuse element construction. A fuse having two current responsive elements in series.
A T2AL 250V fuse is a time delay, 2 amp, glass fuse rated for 250 volts. The L stands for low break capacity.
Yes you can do that as long as it will fit in the fuseholder. It is acceptable to replace a lower Voltage Rated fuse with a higher but NEVER replace a higher with a lower. There are several things to consider when replacing a fuse: 1) The minimum voltage rating of the fuse is equal to or higher than the voltage of the circuit you are placing it in 2) The Amperage rating of the fuse does not exceed the capacity of the circuit you are trying to protect. Always replace a fuse with one that has the same amperage rating. 3) The interrupting rating of the fuse is sufficent for the capacity of the circuit supplying the fuse. If replacing a fuse always use one with an interrupting capacity equal to or greater than the fuse you are replacing.
If an MCB trips you can simply close it and be done. If a fuse blows you need to replace the fuse /fuse wire, not so convenient.
what is fuse law
The time delay fuse allows a momentary overload due to startup current.
we use a time delay fuse at furnace area where heaters are used ect,
A time delay fuse will not blow at the first sign of an overload. It will delay blowing just long enough to allow a motor to start or a compressor to startup.
There is no difference. Slo-Blo is just a trademarked name for a time delay fuse.
Time delay fuse.
what is fuse law
A time delay fuse will allow for a temporary spike in the current (up to 100 or 200% of the fuse rating), such as when starting a motor. A regular (non-time delay fuse) will not allow for any spike over the current rating of the fuse. If you have a motor that pulls 2 amps while running, but pulls 6 ampls while starting, then you will want to use either a 6 amp non time delay fuse, or a 2 amp time delay fuse. If you are talking about pyrotechnics, a time delay (properly called a slow burning) fuse will give you more time to run for cover.
Yes, and you should use a time delay fuse.
No, use a standard fuse.
A fuse is used for protection. If you replace it with a nail, you give up the protection. If the fuse blew, there was a reason, and the fuse protected you from the results of what would have happened if it had not blown, like such minor inconveniences as your TV set getting blasted beyond repair, or your house burning down.
Remove the blown fuse. Replace it with a new fuse.