0
Can the water pressure in the house be too much for a gas hot water tank?
Wiki User
∙ 11y ago
yes and no. usually you want your psi between 65 and 80. otherwise it will cause you problems!!
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How much does a large fish tank wight?
It depends on how much water and how pressure is on the tank.
When you want to set up a water tank why do you put it higher than your house?
because the water flows much faster this way and the water pressure is high
What pressure should you have entering the hot water tank?
House pressure, 75 PSI maximum.
What would cause tank to have good pressure but not allow water to flow through the house?
If it's a bladder tank, it should always have "Air" pressure but if the pump isn't working, you still wouldn't have water in the house.
How much pressure should my water tank bladder have?
The water pressure depends on the residual air pressure in the tank. Normally it should be between 30 -50-psi. Tank air pressure is important, it should be about 27-29 when water is nearly empty.
Could the hot water tank be causing the water pump to be losing pressure?
No. Nothing to do with it. Much more likely there is an air leak between pump and pressure tank, or pressure tank needs a new aircharge.
What does it mean when the water pressure in your house is low?
If you are on a well it means you have a problem in the pressure tank. On city water means pressure in general is down, or your PRV is failing.
What will cause low water pressure on a residential house with a well?
There are many cause of this, but the primary reasons are in the pressure tank. The tank MUST have residual air pressure of around 27 psi to drive the water system. To analyse further I need to know what kind of tank you have and what air pressure is in it when the water ceases to flow. I need to know what pressure your pump starts and if the tank feels heavy (full of water) when the pressure is low.
Why do you need to have a water tank?
If water doesn't go into the pressure tank you will not have water pressure.
What creates water pressure in a home on a municipal system?
When water is pumped from a well, lake, or river it is sometimes sent to a treatment plant and then a water storage tank. This tank is higher than your house and water flows to the lowest open point (your tap). There is .43 psi per foot of water so the higher the tank is above your house the more pressure you will have.
What would make the water pressure in a house go above 80 psi?
Area water authority could have increased water main pressure, no or defective expansion tank in house main water line if house has a backflow preventer installed, or defective /not properly set pressure reducing valve.
How much pressure is in a water tank?
What kind of tank? How much water is in it? Is there air in the tank? What fills the tank? What kind of pressure from where and what?answerIf the tank is gravity fed, multiply .431 times the altitude that the source is above the tank. For example, the reservoir supplying my domestic water system is approximately 200 feet higher than the valley floor I live on. My water pressure is slightly over 80 psi. If the tank is pump fed, and if you have no information on the pump, you will have to put a gauge on the system.
