answersLogoWhite

0


Best Answer

Yes! If you use some plastic mesh. Just follow the directions.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can bondo be used to fill a hole in a back panel?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What do you fill a hole in your car with?

GAS.Answer:It depends on what kind of hole. In a body panel, you might use bondo, fibreglass, or sheet metal. You'll have to ask a more specific question for a more specefic answer.


How to quick fix a dodge caravan se 2000 window?

The only fix not involving removing the door panel is to use plastic and tape to fill the hole.The only fix not involving removing the door panel is to use plastic and tape to fill the hole.


Can you over fill a manual transmission?

Yes, so you fill it up to the fill hole then screw the plug back in.


1996 Pontiac manual trans fluid level?

Simply fill thru the fill hole until fluid starts to run back out of the fill hole, reinstall plug bolt and you're done


Is there any difference in meaning regarding fill in and fill out?

Yes, you can fill in a hole, you can not fill out a hole


What is Oil capacity for gm 3 speed manual trans?

fill it until it starts coming back out of the fill hole


Can a breaker with no connected circuit be left in a breaker panel and marked as disconnected?

yes, it will fill the hole in the panel if you have no blank covers, if you want to be sure it is completely inert, disconnect the power lead and cap it.


How much oil does the rear axle hold on a 1988 Jeep Comanche?

take out the plug and fill it till it comes back out the fill hole


What needs to come off to get to the back of the radio on a 93 Toyota pickup 4x4?

the hole dash panel.


How much fluid to put in a 1998 bravada transfer case?

Fill it till it runs out of the fill hole. Again that's the FILL HOLE, not the DRAIN HOLE. They are separate.


Where is the fill hole located on the 1995 lebaron convertible hydraulic motor?

there is a rubber plug on the top portion of the motor .remove the plug,fill and put plug back on


Where is the transmission fluid fill hole on a 1991 Chevy blazer 4x4?

The fill hole is the dipstick hole itself. You usually need a long funnel to get fluid into it, and it's slow to fill because of this.