Yes, that's what it's for.
to limit the voltage or regulate the same.
Zener is connected in parallel to the circuit
A: They are both diodes. The difference lies in the application. A rectifier is used to rectify AC current into pulsating current. The zener diode is used to regulate a voltage source to the zener voltage when connected in the reverse direction. ************************************************************** If you look at the characteristic curves of a rectifier diode and a zener diode, you will see that they are similar, but the reverse curve of the zener has a much sharper bend at what is called the "knee". It is at this point on the zener's curve at which it operates.
A: A zener is a diode that if reversed voltage is applied will conduct at a certain voltage. This diode zener therefore will conduct at a preset voltage limiting the over voltage to the diode conducting voltage and no more so the load can see the voltage up to the zener voltage and no more because the zener will sink the extra current from over voltage situation.
Yes **************************************** Yes they can but there are pitfalls. A normal diode will have a high reverse breakdown voltage. A zener has a relatively low breakdown voltage (its "zener"voltage). If a zener diode is used as a rectifier it must have a zener voltage at least twice the peak of the applied a.c.
zener diode is a revers bias diode which used for voltage regulation.
If the zener diode is in zener breakdown the voltage across the zener diode remains constant regardless of current (for the ideal zener diode). Real zener diodes have parasitic resistance that causes the voltage across the zener diode to increase slightly with increased current, but due to temperature dependant variations in this parasitic resistance as well as temperature dependant variations in the zener breakdown voltage, this change in voltage in real zener diodes cannot be described by a simple linear factor.
zener diode :zener diode operates under reverse bias voltageideal diode :ideal diode operates under forward bias voltage
Zener diodes attempt to keep the voltage across their terminals constant. They are often used in power supplies to regulate output voltage to 3, 9, 12, 15, etc. volts. Unlike a typical diode, current may be allowed to flow in either direction to regulate the output voltage.
It is a voltage regulator
Yes. The intended use of a zener diode is to be reverse biased at the breakdown voltage. In this mode, the zener has high slope in the current to voltage curve, making it a good choice for voltage regulation.
That depends on the zener voltage rating:"low voltage" zeners are just a simple single diode, the zener diode"high voltage" zeners contain 2 back to back diodes in one package, the zener diode and an ordinary diode that is reverse biased when the zener diode is forward biased to block forward conduction of the zener and protect it from overcurrent damage if installed backwards by mistakeThus in "low voltage" zeners when forward biased they will have a normal diode drop (e.g. 0.7V), but "high voltage" zeners when "forward biased" they will act open due to the reverse biased blocking/protection diode in series with the zener.