This is not a good idea to do. Sometimes just that little bit of extra current that the 45 amp fuse will allow to reach the 40 amp load might be enough to destroy the device.
You can replace a higher rating fuse with a lower rating provided it works with the device without constantly blowing. So try the 30 amp fuse in your lawnmower and if it doesn't blow and the mower works okay, you are fine. If it blows you will have to go back to 40.
What size is the wire? AWG 10, 600V is rated for 30 amps. Any AWG less than 6 would also be ok for a 30 amp circuit....
Not a good idea. The 15 amp fuse will be protection a #14 wire which is rated for 15 amps maximum capacity. By changing the 15 amp fuse to a 30 amp fuse you would then be allowing 30 amps maximum capacity on a #14 wire. By doubling the load the extra heat generated on the smaller wire could be enough to melt the insulation from the wire and that could cause the wire to short out. If the wire shorts out inside the wall it means the removal of the wall board to replace the wire to restore the circuit to an operational condition. The proper wire sizing for a 30 amp fuse is, #10 copper wire with an insulation rating of 90 degrees C.
Use a 30 amp breaker.
Depends on the wire size you are using. If the generator breaker is a 30 amp then install a 30 amp breaker.
This is a unclear question, and not easy to answer. In your fuse panal, their will be a range of fuses, from 5 amp, up to 30 amp. On your fuse panal cover, should be a digram of your fuse panal, and which amp fuse goes into which slot.
Not a good thing to do! If you are blowing 10 amp fuses, you have a problem with that circuit. Putting a 30 amp fuse in its place can do more damage.
A 30 amp fuse is required.
The blower motor could stop working if it blew the 20 amp fuse. That's probably the worst that would happen. You should replace it with a 30 amp fuse, if that is what's called for in your manual.
The 1965 Chevrolet Impala SS fuse box requires a 20 amp fuse for the taillights. A 30 amp fuse can be used when a 20 amp fuse is not available.
circuit breaker fuse
30 amp
It should work with a 20 amp, just not as long. Wipers use a fair amount of current so the factory puts a 30 amp in. Perhaps that particular 20 amp is bad or it blew as soon as you turned the wipers on.
What is the 40 amp RSI fuse in a Lexus rx 300 fuse box
Yes, as long as it doesn't blow. You can always go lower with a fuse, but not higher.
If a 30 amp blows you have a short somewhere. Depends for which circuit, you will have to track it from the unit back to the fuse.
If the car is a Diesel there is 30 amp open fuse on the firewall