0
The actuator is located on top of the heater box and can be accessed by fully opening the glove box and looking in the upper left hand corner. Generally, the actuator motor is not the problem, but a broken blend door. For information on how to diagnose and fix the problem, you can check at www.heatertreater.net. This is a very common problem and the fix is very expensive at the dealer. HeaterTreater is a cheap, easy alternative.
cgallen
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you remove a blend door actuator out of a 99 f150?
get a person who does that work to come over
Where is the blend door actuator 99 ford windstar?
The Blend Door actuator on the Ford Windstar can be found by removing the glovebox. A broken blend door actuator is almost as common as a broken blend door itself. Typically, the fix requires disassembling the entire dash and replacing the whole plenum box, which can be a costly repair. Linked here is a video from www.heatertreater.net demonstrating how to access components of the plenum box for repair without disassembling the entire dash. heatertreater.net/Windstar%20Video.html This details the best DIY option on how to replace a broken blend door or actuator.
Your front ac doesn't blow cold air on your ford windstar1999 you changed the blend door actuator what could it be?
I have the opposite problem with my 99 Windstar - front vents will not go to heat, which is real fun in winter. I replace the blend door actuator to no avail, and was told the actual blend door was broken, which would require a replacement of the "heater box", for the low low price of $1200. I am currently looking for plan "B".
Where is the blend door motor located on a 99 Ford Taurus?
The blend door actuator motor is on the front side of the box and can be seen by fulling opening the glove box and looking to the left over the transmission tunnel. Pictures and diagnostic procedures are available at heatertreater.net.
99 Grand Cherokee heater actuator problems?
It's actually rare for the actuator motor to fail. The problem is usually a broken blend door and the computer shutting down the system because it detected a fault. You can find diagnostic information at heatertreater.net
Why is heat very faint on 99 4.3l v6 blazer?
Assuming the blower motor is working, it could be a bad thermostat, plugged heater core or a bad temp blend door actuator.
Blend door actuator and heater core on 99 ford windstar works why are you still getting cold air?
Suspect a plugged up heater core then.See "Related Questions" below for more
How do you replace heater control valve on 99 s10?
The temp blend door actuator is located on the HVAC unit behind the dash assembly. To replace the temp blend door actuator the dash assembly needs to be removed. This is a fairly large job with to many steps to post here. If you intend on doing it yourself I would recommend purchasing a shop manual for that vehicle. The manual will pay for itself after the first job.
How do i shut off heater coil on a 99 suburban?
If you are getting hot air no matter how you adjust the temp control switch, the temp blend door actuator is probably at fault. The actuator is located under the passenger side of the dash. You will have to remove the lower plastic cover above the passengers foot area to gain access to it.
What is the difference between a 99 and a 97 explorer door?
about 2 years
Why does air conditioner work on back and top panel on 99 ford expedition but not in front were it hits the front passangers?
Blend Door ProblemYour problem sounds like the common blend door problem on the Ford Expeditions, and Ford Explorer. The door is on a vertical axis and when it breaks, it can swing back and forth randomly giving heat or AC or nothing. The difference on acceleration is the force placed on the door swinging it one direction.You can check the operation by fully opening the glove box, removing the actuator motor on top of the plenum box and examining the blend door axle (the actuator is under the unit on top of the hump behind the flexible black plastic cover. It is on top of the unit, behind the glove box in the 2002 F-350 though). Pictures of the common fail signature are available on the Related Links below. There are several "free" fixes that mostly are worth what you pay for them. The solution on the web site is solid and proven over hundreds of vehicles and will resolve the problem once and for all.
How do you find the problem with a 99 Civic LX right power door lock that will not operate?
your door latch is stuck or you need a new door actuator for the door locks in that door. Honda very rearly has problems with there wiring! Good luck....Michael
