Replace the ECM.
Disconnect the battery for a few seconds, then reconnect.
Disconnect your battery+ and reconnect it after 5-10 seconds.
disconnect the battery for 15 seconds then reconnect.
disconnect the negative battery cable for 30 seconds and reconnect it.
disconnect negative battery cable for 30 seconds and reconnect.
disconnect negative battery terminal depress brake petal fully for 30-45 seconds reconnect negative battery terminal
After repairs are made. disconnect the battery cables, wait a few seconds and reconnect, that usually clears the codes, dash lights.......
To turn off the check engine, disconnect the positive battery cable for 30 seconds, then reconnect.
Disconnect + cable on your battery , go inside vehicle , sit in drivers seat , apply pressure to brake pedal for 5 seconds as if you were making a stop . Reconnect Battery , should be clear .
disconnect the battery with the lights on and then press the horn for 5 seconds. This will erase the codes in the chip. Then reconnect the battery and the service light should be off.
Just disconnect the battery negative cable in the engine compartment for a few seconds, and reconnect. If the problem has been corrected, then the fault will be reset.
Change the oil and the oil filter, than disconnect the negative side of the battery for 10 seconds than reconnect.